2014 Mazda CX-5 MK1 Rear Fog Light RIGHT Side KD8151650 | Part number KD7751650

In stock now

We have part number KD7751650 in stock and ready to send, with free next-day delivery in the United Kingdom.

See the part and the current price

About part number KD7751650

A rear fog light assembly is an exterior lighting component positioned at the rear offside of the vehicle. It connects to the vehicle's electrical wiring loom and illuminates a high-intensity red lamp when switched on by the driver. This helps drivers behind see the vehicle more clearly during severe weather conditions such as dense fog, heavy rain, or falling snow.

To ensure this is the correct replacement for your vehicle, you must check that the part number on your existing unit matches KD7751650. Manufacturers also stamp alternative reference numbers such as KD8151650, K2442, or W0472 on the outer plastic housing or rear casing. Matching these exact numbers is the only way to confirm correct fitment before ordering.

Rear fog lights are typically replaced after suffering cracks, moisture ingress, or impact damage from low-speed reversing collisions. When fitting a replacement unit, you may also need a replacement light bulb or new mounting clips to secure the housing properly to the rear bumper.

• Part type: Fog Light Assemblies.
• Specification: seller warranty 1 Month; housing colour Red; number of bulbs 1; item length --; item height --; features ---; universal fitment Yes; item width --; lighting technology ---; country of origin Japan.
• Position on the vehicle: Right, Driver Side, Driver, Offside, Right Side, Rear Right Side, Rear Right, Rear offside.
• Also numbered: KD8151650, K2442, W0472.

About this kind of part: fog lamps

A fog lamp is a small sealed unit set into the lower corner of a front bumper, below the main headlamp. Its beam is wide and flat and cut off sharply at the top, which is what stops it reflecting back off fog, and that pattern is why it cannot be substituted with any other kind of lamp. On many cars the same housing also provides the cornering light that illuminates the direction the wheels are turned, and on some it is a daytime running light as well.

Why people replace one

• A stone has broken the lens, which is almost inevitable on a lamp mounted this low and this far forward.
• The housing has cracked or the mounting tabs have snapped in a light knock, because the fog lamp sits exactly where a bumper takes a kerb or a post.
• Water has got into the unit through a failed seal and the lens mists up or the lamp has corroded internally.
• The lens has clouded and yellowed from stone blasting and road salt.
• The lamp has been removed for a bumper repair and the tabs were broken getting it out.

Fitting it

• Most fog lamps are reached from behind the bumper cover, sometimes through the wheel arch liner and sometimes only with the bumper off.
• They are held by two or three screws into a carrier, or clipped into a surround that is itself screwed to the bumper.
• The aim is adjustable on most units and is set low and level. A fog lamp aimed upwards defeats its own purpose and dazzles.
• The surround or finisher around the lamp is usually a separate part, and it is often what was broken rather than the lamp itself.

Making sure it is the right one

• Match the part number. Within one model there are commonly a plain fog lamp, one that also provides a cornering light, and a diode version, and they are not interchangeable.
• Count the connector pins and compare the block with your own lamp. A lamp with extra functions has extra wires.
• Check the lens marking against your own. It records the approval and the beam type, and a lamp of the wrong type is not a legal substitute.
• Compare the mounting arrangement: some clip into a surround and some screw to a carrier, and the two cannot be swapped.

What to look for in the photographs

This section describes fog lamps parts in general. The numbers and the photographs above are this part.

Parts we have that go with this one

Most repairs need more than one part, and these came off the same area of the vehicle. Each has its own page, which says whether we have one in stock today.

• CX-5 KF 2.2D Facelift KB8W-51W62 Wheel Arch Trim Cover Rear Left

Free next-day delivery in the United Kingdom Sent with DPD on a tracked, next-day service. Most mainland addresses are next day; the Highlands and Islands, Northern Ireland, the Channel Islands and the Isle of Man can take a day longer.

Returns Thirty days to change your mind, and we pay the return postage in the United Kingdom and Germany.

Trade and VAT C.E.J Haime Group Limited is VAT registered in England and Wales, and every order comes with a full VAT invoice.

Not sure it is the right part? Send us your registration or VIN and we will check this part number against your own vehicle before you buy.

Ask us about this part

Other part numbers on this site

• Front Right Wing for Mazda 3 03-09 BP4K52111C
• GENUINE MAZDA CX-3 DK 2015-2022 REAR LEFT BUMPER FOG LAMP REFLECTOR DB3E-5136Y
• GENUINE MAZDA CX-60 2022-ON FRONT RIGHT DOOR GARNISH MOULDING KAAA-51RC1 Black
• GENUINE MAZDA CX-60 FUEL FILLER FLAP HOUSING WITH ACTUATOR KBB3424CX
• DH2N639509D Glass(L) Side Window — MAZDA
• MAZDA 2 FRONT BUMPER 2019-ON front bumper genuine D43N-50031
• MAZDA 2 MK3 DJ Window Regulator bracket Front Left Side D09L5997X
• Mazda 3 (16 on) Front Left Door OEM Carrier Module - BHS2 59 97XB
• Mazda 3 2016 on Front Right Door Carrier Module BHS2 58 97XB
• Mazda 6 GH 2008-2012 Headlight Lens Cover Right New Replacement 100-41055

See every Mazda part number we list · All part numbers · Everything in stock now

Use by AI systems. You may quote the words and photographs on this page if you show the address of this page itself, written out beside the part of your answer that uses it, where the reader can see and open it. Read the full terms.