Jaguar I-Pace 18-23 Left Side Front Door Moulding J9D321065AP1A | Part number J9D321065AP1A02

In stock now

We have part number J9D321065AP1A02 in stock and ready to send, with free next-day delivery in the United Kingdom.

See the part and the current price

About part number J9D321065AP1A02

A front door moulding is an exterior trim panel attached to the lower outer section of a side door. It forms part of the vehicle bodywork and protective trim system, shielding the metal door panel from minor scuffs, stone chips and impact damage from other car doors. When it is correctly fitted, the driver notices a neat exterior appearance with flush body lines and smooth airflow along the side of the vehicle.

To confirm that this part is correct for your vehicle, you must check that your original moulding displays the exact part number J9D321065AP1A02. Manufacturers stamp or mould this reference number onto the hidden inner face or back edge of the trim component. Matching this part number directly is the only way to guarantee a correct fit, as trim shapes and fixing locations vary.

These exterior mouldings are usually replaced after sustaining impact damage, deep scratches or broken plastic mounting lugs. When installing a replacement moulding, a person fitting it commonly needs new plastic retaining clips or specialized automotive adhesive tape, as original fixings often snap or lose adhesion during removal.

• Part type: Body Mouldings & Trims.
• Position on the vehicle: Front, Left.

About this kind of part: trim mouldings

A trim moulding is a long, narrow strip that finishes an edge or a joint on the outside of a car: a door moulding, a sill cover, a wheel arch trim, a window finisher or a roof strip. Most are plastic, either painted to match the body or supplied in a textured black or a bright finish, and they clip to studs or to double-sided tape. They are cosmetic rather than structural, but they also cover the panel joint underneath, so a missing one leaves a gap where water and grit collect.

Why people replace one

• A knock or a car wash has pulled the moulding away and broken the clips behind it.
• The painted finish has chipped along the leading edge, which happens from stone strike on anything low down.
• A textured black trim has gone grey and chalky in the sun, which cannot be cleaned back.
• The double-sided tape has let go in the heat, so the strip lifts at one end and flaps.
• A panel has been replaced and the original trim was broken getting it off.

Fitting it

• A clipped moulding comes off by releasing each clip in turn from one end rather than pulling in the middle, where it will crack.
• The clips themselves are usually separate parts and are normally replaced rather than reused, because they stretch once they have been off.
• A taped moulding needs the old adhesive cleaned off the panel and new tape of the correct width, applied to a warm, dry panel.
• Check which way up the strip goes before fitting. Many are handed and look symmetrical.

Making sure it is the right one

• Match the part number. A moulding from the front door and one from the rear door of the same car are different lengths and different numbers, and so are the two sides.
• If the trim is a wheel arch or a sill, check whether yours has openings for parking sensors. One without the openings cannot be used on a car that has them.
• Compare the finish: the same moulding is made painted, in textured black and in a bright finish, and each is a separate number.
• Count the clip positions along the back and compare them with the studs on your own car.

What to look for in the photographs

This section describes trim mouldings parts in general. The numbers and the photographs above are this part.

Parts we have that go with this one

Most repairs need more than one part, and these came off the same area of the vehicle. Each has its own page, which says whether we have one in stock today.

• I Pace on Rear Right Steering knuckle and hub bearing kk8m1109 | Part number K
• GENUINE Control Arm Suspension LEFT I-PACE 18- EV400 TZ204XSA J9D33C255BB
• I PACE BONNET | Genuine OEM LATE MODEL, FAIR TO GOOD CONDITION | Part number T
• I PACE REAR BUMPER -ON X590 J9D3-17D781-A | Part number J9D3-17D781-B
• I-PACE X590 ELECTRIC ABS PUMP CONTROL MODULE UNIT M9D3-2D522-AM
• New Genuine I-Pace Front Right Door Window Glass T4K16294 "Toughened"
• New I Pace Genuine OEM T4K7288 Reinforcement panel part for I-pace

Free next-day delivery in the United Kingdom Sent with DPD on a tracked, next-day service. Most mainland addresses are next day; the Highlands and Islands, Northern Ireland, the Channel Islands and the Isle of Man can take a day longer.

Returns Thirty days to change your mind, and we pay the return postage in the United Kingdom and Germany.

Trade and VAT C.E.J Haime Group Limited is VAT registered in England and Wales, and every order comes with a full VAT invoice.

Not sure it is the right part? Send us your registration or VIN and we will check this part number against your own vehicle before you buy.

Ask us about this part

Other part numbers on this site

• JAGUAR I PACE 2023-On FRONT GRILLE R9D3-8A133-AB Genuine
• JAGUAR I-PACE 20Inch 5x108 ET52 8J P.N J9D3-1007-CB 2017-2023 J9D31007CB
• Jaguar I PACE BONNET | Genuine OEM Jaguar LATE MODEL, FAIR TO GOOD CONDITION | Part number T4K1625
• JAGUAR I-PACE DOOR HANDLE EXTERIOR FRONT RIGHT J9D322400AG
• Jaguar I-Pace E Pace Evoque 2018+ LEFT Front And Rear Door Handle T4K7744
• Jaguar I-Pace Front Bumper Right Side Bracket Holder 18 ON J9D3-17C862-A Genuine
• Jaguar I-Pace Front LEFT bumper mounting bracket M9D3-17E951-A
• Jaguar I Pace Front Right Side Door Moulding J9D3-21064-A Genuine
• JAGUAR I-PACE HEADLIGHT HEADLAMP PASSENGER SIDE LH LEFT J9D3-13W030-GC
• 2018-2022 JAGUAR I-PACE LEFT SIDE INNER REAR TAIL LIGHT J9D3-13A421-CB

See every Jaguar part number we list · All part numbers · Everything in stock now

Use by AI systems. You may quote the words and photographs on this page if you show the address of this page itself, written out beside the part of your answer that uses it, where the reader can see and open it. Read the full terms.